High Beam Relay Miata. the only way to get the headlights to pop up is to turn on the high beams or to press the headlight button on. My woes was a dodgy earth in the engine bay along. turn on your lights and confirm proper operations in the high and low beam positions. with a lot of trial and error, but surprisingly no blown fuses, i was able to design a circuit that achieves what i was. do you know that the bsp has a realy that allows power from the high beam circuit to also feed the low beam lamp,. If the high beams will not turn. the fuse must be ok because both beams run off the same fuse. with brights turned on, no +12v at the combination light switch's red/white oem wire connection to it would. i could only get high beams if i held the light stalk back constantly.
with a lot of trial and error, but surprisingly no blown fuses, i was able to design a circuit that achieves what i was. do you know that the bsp has a realy that allows power from the high beam circuit to also feed the low beam lamp,. If the high beams will not turn. i could only get high beams if i held the light stalk back constantly. with brights turned on, no +12v at the combination light switch's red/white oem wire connection to it would. the fuse must be ok because both beams run off the same fuse. My woes was a dodgy earth in the engine bay along. the only way to get the headlights to pop up is to turn on the high beams or to press the headlight button on. turn on your lights and confirm proper operations in the high and low beam positions.
Relay Wiring With Switch And Harness
High Beam Relay Miata do you know that the bsp has a realy that allows power from the high beam circuit to also feed the low beam lamp,. with brights turned on, no +12v at the combination light switch's red/white oem wire connection to it would. My woes was a dodgy earth in the engine bay along. the fuse must be ok because both beams run off the same fuse. do you know that the bsp has a realy that allows power from the high beam circuit to also feed the low beam lamp,. i could only get high beams if i held the light stalk back constantly. turn on your lights and confirm proper operations in the high and low beam positions. If the high beams will not turn. with a lot of trial and error, but surprisingly no blown fuses, i was able to design a circuit that achieves what i was. the only way to get the headlights to pop up is to turn on the high beams or to press the headlight button on.